5.
What should you do to a hot generator before removing the engine head assembly?
A.
Purge the generator to remove hot gases.
B.
Remove the air hose from the air coupling.
C.
Check the fuel pressure.
D.
Drain the frame assembly drain pan.
6.
While performing troubleshooting procedures when the circuit breaker CB1 moves to the OFF
position when the power switch is set to ON, what should you check for next if circuit breaker
CB1 moves to the OFF position with the air compressor 1J2 connector disconnected?
A.
A short circuit in the fog oil pump assembly
B.
A short circuit in the smoke generator cable assembly
C.
A short circuit in the air compressor cable assembly
D.
A damaged engine valve
7.
When you complete the troubleshooting procedures outlined in the technical manual and the
equipment still does not function, what action should you take?
A.
Start again.
B.
Notify organizational maintenance.
C.
Begin organizational troubleshooting procedures.
D.
Check the engine valve.
4-17
CM3305
Previous Page
