c. Save pads under hinged heater.
Swing out heater, remove and save
two loose pads, and swing heater back in.
d. Remove pull tab and rub Lewisite Rubbing Tab (refer back to Figure
1-6).
e. Hold sampler with test spots or arrow pointing up, and using Heater
Pads, crush the two outer ampoules marked No. 3, (Refer back to Figure 1-7).
f. Turn sampler upside down and wet test spots.
g. Hold sampler with test spots or arrow pointing down, put your thumb
on protective strip over middle test spot (Figure 1-15).
h. Swing heater away from test spot (Figure 1-16).
Figure 1-15.
Test Spots Down
i. Activate First Heater Ampoule (Figure 1-17).
DO NOT USE HEATER PADS.
Swing heater immediately over test spot.
j. After two minutes, swing heater away from test spot (Figure 1-17).
Swing protective strip away from test spots.
k. Place sampler under box or can for about 10 minutes (Figure 1-18).
The instruction side should be face up.
l. After 10 minutes remove sampler from box or can.
Hold sampler by
the protective strip.
m. Activate second heater
ampoule
(Figure
1-19).
Swing
heater
immediately over test spot.
CM 1301
1-16
Previous Page
