Figure 11. Checking Generator Belt Tension

Maintenance of the M12A1 PDDA
Page Navigation
42

Lesson 3/Learning Event 2

FIGURE 11.

CHECKING GENERATOR BELT TENSION.

Step 2.

If the top of the battery has cracked or blistered sealing

compound, notify organizational maintenance personnel.

See that the

electrolyte level in each cell is approximately three-eighths of an inch

above the separators.

See that the ground strap is clamped to the NEG

terminal on the battery. See that the POS cable is clamped to the frame and

is fastened to the starter solenoid on the engine.

See that the ground

(NEG) strap is clamped to the skid and is bolted to the engine flywheel

housing. See that the terminals on the battery are coated with automotive

and artillery grease (GAA) to prevent corrosion.

If the battery must be

recharged or replaced, notify organizational maintenance personnel.

Maintenance of the Generator.

Maintenance of the generator is performed by

using the following steps.