Lesson 1/Practice Exercise
PRACTICE EXERCISE FOR LESSON 1
Instructions
You have just finished reading the instructional material for Lesson 1. This lesson covered the
purpose, capabilities, limitations, and operating procedures of the 50-GPM Pump. It is now time
to check your understanding of the lesson. This is done by completing the practice exercise
below. All of the questions are multiple-choice and are intended to measure your understanding
of the procedure used in performing the task. There is only one correct answer to each question.
Try to answer all of the questions without referring to the lesson material.
When you have completed all of the questions, turn the page and check your answers against the
correct responses. Each correct response is referenced to specific portions of the lesson material
so that you can review any questions you have missed or do not understand. When you have
completed your review, continue to the next lesson.
1. Operating the 50-GPM Pump dry will damage the
a.
engine.
b.
throttle.
c.
carburetor.
d.
sea.
2. You should strain fuel before adding it to the fuel tank when the 50-GPM Pump is operated in
a.
high humidity.
b.
extreme cold.
c.
extreme heat
d.
sand and dust
3. After performing before-operation checks and services and priming the pump, you should
next
a.
clean the fuel filter.
b.
fill the fuel tank.
c.
close the choke.
d.
pull the starter rope briskly.
13
Previous Page
