OPERATION OF THE PERSONNEL SHOWER
As mentioned earlier, water for showers can be pumped from either the tank unit or from a natural water
source.
To operate the personnel shower, use the following procedures.
Step 1. Connect the suction hose to the pump unit. Depending on the source of water used, connect the
other end of the hose to either the foot valve or the tank drain valve. Make other connections and valve
adjustments necessary for discharging hot water (operation no. 7 on the STARTING PROCEDURE
instruction plate) depending upon the source of water used.
NOTE: The required unit configuration for showering personnel with water from the tank is shown in
Figure 43. The required configuration of the unit for showering personnel with water drawn
from a natural water source is shown in Figure 44.
Figure 43. Showering personnel with water from the tank.
93
Previous Page
